Pipe clips assembly
The GOEMA pipe clips from Akatherm are made from
PP. They are available in metric series with de 16 to 180 mm and in inches series with de 3/8" to 6".
Read more about the assembly of GOEMA pipe clips:
- Clamp principle
-
In principle the clip consist of a base with two upstanding flexible arms. When the pipe is pushed into the clip the two arms are forced to move outwards and the pipe is clamped into the clip. The restraining clip is mounted over the two arm ends to assure a long term fixation of the pipe.
Due to relaxation of the stress in the arms of the clip the fixation force will reduce to a minimum.
In the long run the pipe clip will operate as a support bracket which prevents sideward movement and allows unrestricted axial pipe movement.
- Assembly guidelines
-
- According to the guidelines mentioned in our Specification Manual PE100 pressure fittings
- Clamp distance according to DIN 16928 and adjusted for specific pipe material / application
- Always use a retaining clip to prevent pipe to be is pushed out of the clip
- 4 mm bolt/screw slots are used
- Advised mounting guidelines:
Mounting
Number
of
screwsClamp distance reduction factor
Horizontal on floor
2
-
Vertical on wall
2
0,8
Horizontal on wall
3
0,9
Horizontal on ceiling
3
0,7
